A schematic would get you a precise answer ...

Posted by Naz (A) on April 4, 2016 at 17:20:28

In Reply to: Simple ! posted by airtime on April 4, 2016 at 16:14:29:

The reason you are are getting mixed messages is that everyone has to guess the circuit config.

FWIW, and from experience I'd be surprised if changing value from 10uF to 100uF will change sound much for technical reasons other than cap quality ... assuming the cap is merely a coupling cap. It would only have the effect of reducing the LF corner frequency, which would typically already be well below an audible frequency, perhaps a few hertz.

If it's not a coupling cap then the consequences could be greater. A schematic will get you the answer you seek.

Naz

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Ok, I'm going to ask this cap question here because I can't seem to get an answer - airtime 06:57:40 04/04/16 (12)

RE: Ok, I'm going to ask this cap question here because I can't seem to get an answer - Eli Duttman 12:46:13 04/04/16 (2)

Original intent - airtime 06:37:28 04/05/16 (1)

RE: Original intent - Lew 12:31:12 04/08/16 (0)

RE: Ok, I'm going to ask this cap question here because I can't seem to get an answer - Michael Samra 09:18:17 04/04/16 (4)

RE: Ok, I'm going to ask this cap question here because I can't seem to get an answer - airtime 16:17:25 04/04/16 (3)

RE: Ok, I'm going to ask this cap question here because I can't seem to get an answer - Lew 12:33:46 04/08/16 (0)

RE: Ok, I'm going to ask this cap question here because I can't seem to get an answer - Michael Samra 18:12:51 04/04/16 (1)

22uf replaced with 100uf - airtime 10:54:12 04/06/16 (0)

RE: Ok, I'm going to ask this cap question here because I can't seem to get an answer - Palustris 09:03:09 04/04/16 (2)

Simple ! - airtime 16:14:29 04/04/16 (1)

A schematic would get you a precise answer ... - Naz 17:20:28 04/04/16 (0)

Do you have schematic of circuit in question? (n/t) - FenderLover 07:58:17 04/04/16 (0)

Follow Ups

A schematic would get you a precise answer ... - Naz 17:20:28 04/04/16 (0)

A schematic would get you a precise answer ...

Post a Message!