|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: This is what is gong on... posted by Balle Clorin on March 26, 2016 at 01:45:30:
Thanks for your information.
Indeed the source impedance matters, heavy feedback compensates for a non linear curve. Nevertheless measurements do nothing for me, loudspeaker amplitude curves, room influences are bigger issues.
My Magnepan MG1-c with a little tweak on the filter has an impedance of 5 Ohm on every frequencie. As there is no EMF feedback to the amplifier Valves or Solid State work almost or entirely the same, yet I prefer my valve amplifier, in my case without feedback. Natural sound, various Solid State amp in the past all had their own sound, from good to very bad. Even a single ended 6BQ5 amp at low volume sound musical and natural versus Solid State amp's.
I wish for a solid state amp with good sound, cheaper, easyer, no expensive valves to replace, etc. but never found one.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: This is what is gong on... - huubdas 16:28:58 03/26/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
