|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: How did you want to "better" your PSU? posted by kylealers@gmail.com on August 16, 2015 at 02:33:38:
You sure you want to run the 12AX7 after the 5670? I thought you wanted one line with no TS and the other one with a TS. I think the gain stage with one 12AX7 as input tube is sufficient for your needs.
Just run another input into the 68k-ohm resistor before the first half of the 12AX7. OUT #1 from the 5670 to the bass amp input --- not connected to the 12AX7. OUTPUT #2, into a separate input of the bass amp.
Have each input jack ground out, when not in use. Then, plug the bass guitar into whichever gain stage that you want (no stack or tone stack).
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How did you want to "better" your PSU? - FenderLover 03:54:12 08/16/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
