You are welcome.

Follow Ups Full Thread

Topic - D.I.Y bass tube pre amp - kylealers@gmail.com 08:37:00 07/27/15 (82)

Duncan Tone Stack Calculator - FenderLover 08:57:46 07/27/15 (81)

RE: Duncan Tone Stack Calculator - kylealers@gmail.com 10:20:31 07/27/15 (80)

RE: Duncan Tone Stack Calculator - FenderLover 17:40:26 07/27/15 (79)

RE: Duncan Tone Stack Calculator - kylealers@gmail.com 23:21:12 07/27/15 (78)

RE: Duncan Tone Stack Calculator - FenderLover 01:48:08 07/28/15 (77)

RE: Duncan Tone Stack Calculator - kylealers@gmail.com 01:59:19 07/28/15 (76)

No - FenderLover 02:36:30 07/28/15 (75)

RE: No - kylealers@gmail.com 02:59:34 07/29/15 (74)

Yes. - FenderLover 04:29:08 07/29/15 (73)

RE: Yes. - kylealers@gmail.com 04:47:41 07/29/15 (72)

RE: Yes. - kylealers@gmail.com 04:49:54 07/29/15 (71)

Not quite - FenderLover 06:08:54 07/29/15 (70)

RE: Not quite - kylealers@gmail.com 08:48:23 07/29/15 (69)

microphony - FenderLover 08:56:27 07/29/15 (68)

RE: microphony - kylealers@gmail.com 10:26:36 07/29/15 (65)

No. Can't be seen. - FenderLover 10:33:43 07/29/15 (64)

RE: No. Can't be seen. - kylealers@gmail.com 11:00:52 07/29/15 (63)

Good luck! - FenderLover 18:18:10 07/29/15 (62)

RE: Good luck! - kylealers@gmail.com 04:52:55 07/31/15 (0)

RE: Good luck! - kylealers@gmail.com 04:10:28 07/31/15 (60)

Nice delivery. - FenderLover 04:21:50 08/01/15 (59)

RE: Nice delivery. - kylealers@gmail.com 04:37:29 08/01/15 (58)

Approx voltage drop - FenderLover 07:16:07 08/01/15 (57)

RE: Approx voltage drop - kylealers@gmail.com 09:31:21 08/02/15 (56)

Either one piece bridge or four diodes should be fine - FenderLover 09:35:45 08/02/15 (55)

RE: Either one piece bridge or four diodes should be fine - kylealers@gmail.com 10:02:01 08/02/15 (54)

Sorry... 230VAC - FenderLover 14:08:23 08/02/15 (53)

RE: Sorry... 230VAC - kylealers@gmail.com 22:52:09 08/02/15 (52)

Voltage on plates and cathode will change... - FenderLover 00:29:52 08/03/15 (51)

RE: Voltage on plates and cathode will change... - kylealers@gmail.com 00:57:35 08/03/15 (50)

Microphonics - FenderLover 05:00:04 08/03/15 (49)

RE: Microphonics - kylealers@gmail.com 07:05:24 08/03/15 (48)

RE: Microphonics - FenderLover 14:42:36 08/03/15 (47)

RE: Microphonics - kylealers@gmail.com 23:45:01 08/04/15 (46)

Cathode-tied resistor - FenderLover 04:22:37 08/05/15 (45)

RE: Cathode-tied resistor - kylealers@gmail.com 01:11:36 08/07/15 (44)

Not sure about pin-outs - FenderLover 23:40:22 08/07/15 (43)

RE: Not sure about pin-outs - kylealers@gmail.com 23:56:22 08/07/15 (42)

Maybe the schemo started to compensate for the 5670? - FenderLover 06:59:03 08/08/15 (41)

RE: Maybe the schemo started to compensate for the 5670? - kylealers@gmail.com 07:43:04 08/08/15 (40)

No... 5670 is 6.3VAC in series - FenderLover 18:24:41 08/08/15 (39)

RE: No... 5670 is 6.3VAC in series - kylealers@gmail.com 00:01:50 08/09/15 (38)

RE: No... 5670 is 6.3VAC in series - FenderLover 07:23:58 08/09/15 (37)

RE: No... 5670 is 6.3VAC in series - kylealers@gmail.com 22:54:25 08/09/15 (36)

Wait... didn't this pre-amp work before? - FenderLover 00:51:54 08/10/15 (35)

RE: Wait... didn't this pre-amp work before? - kylealers@gmail.com 01:25:02 08/10/15 (0)

RE: Wait... didn't this pre-amp work before? - kylealers@gmail.com 01:06:08 08/10/15 (33)

You can hook the 12AX7 in parallel, using that heater tap - FenderLover 01:36:50 08/10/15 (32)

RE: You can hook the 12AX7 in parallel, using that heater tap - kylealers@gmail.com 09:15:14 08/10/15 (0)

RE: You can hook the 12AX7 in parallel, using that heater tap - kylealers@gmail.com 08:33:28 08/10/15 (30)

No... all you need is one 6.3VAC or 6.3VDC source - FenderLover 15:02:41 08/10/15 (29)

RE: No... all you need is one 6.3VAC or 6.3VDC source - kylealers@gmail.com 22:25:24 08/10/15 (28)

You are welcome. - FenderLover 23:15:48 08/10/15 (27)

RE: You are welcome. - kylealers@gmail.com 02:06:41 08/11/15 (25)

Look for a good silverface Dual Showman to restore - FenderLover 07:34:44 08/11/15 (24)

RE: Look for a good silverface Dual Showman to restore - kylealers@gmail.com 08:00:50 08/11/15 (22)

There aren't many good DIY amp kits in that power range - FenderLover 08:05:56 08/11/15 (21)

RE: There aren't many good DIY amp kits in that power range - kylealers@gmail.com 08:53:25 08/11/15 (20)

Sure... - FenderLover 09:44:08 08/11/15 (19)

RE: Sure... - kylealers@gmail.com 09:52:22 08/11/15 (17)

None at all - FenderLover 13:57:31 08/11/15 (16)

RE: None at all - kylealers@gmail.com 12:17:55 08/12/15 (14)

Yes, only if you are going to use the tap in AC form - FenderLover 22:30:34 08/12/15 (13)

RE: Yes, only if you are going to use the tap in AC form - kylealers@gmail.com 22:39:15 08/12/15 (12)

100-ohm or 220-ohm will be fine. - FenderLover 00:20:44 08/13/15 (11)

RE: 100-ohm or 220-ohm will be fine. - kylealers@gmail.com 02:31:50 08/13/15 (9)

Cool! - FenderLover 07:13:20 08/13/15 (8)

RE: Cool! - kylealers@gmail.com 03:35:28 08/14/15 (7)

center tap - FenderLover 07:15:02 08/14/15 (6)

RE: center tap - kylealers@gmail.com 01:44:30 08/15/15 (5)

How did you want to "better" your PSU? - FenderLover 07:36:24 08/15/15 (4)

RE: How did you want to "better" your PSU? - kylealers@gmail.com 08:08:55 08/15/15 (3)

RE: How did you want to "better" your PSU? - FenderLover 08:38:36 08/15/15 (2)

RE: How did you want to "better" your PSU? - kylealers@gmail.com 02:33:38 08/16/15 (1)

RE: How did you want to "better" your PSU? - FenderLover 03:54:12 08/16/15 (0)

BTW... - FenderLover 00:21:58 08/13/15 (0)

You need to know... - FenderLover 06:35:22 08/12/15 (0)

Layout link - FenderLover 09:46:09 08/11/15 (0)

DS schematic - FenderLover 07:41:26 08/11/15 (0)

Portaflex B15N - FenderLover 23:18:35 08/10/15 (0)

RE: microphony - kylealers@gmail.com 09:47:10 07/29/15 (1)

RE: microphony - FenderLover 10:35:35 07/29/15 (0)

Follow Ups

You are welcome. - FenderLover 23:15:48 08/10/15 (27)

RE: You are welcome. - kylealers@gmail.com 02:06:41 08/11/15 (25)

Look for a good silverface Dual Showman to restore - FenderLover 07:34:44 08/11/15 (24)

RE: Look for a good silverface Dual Showman to restore - kylealers@gmail.com 08:00:50 08/11/15 (22)

There aren't many good DIY amp kits in that power range - FenderLover 08:05:56 08/11/15 (21)

RE: There aren't many good DIY amp kits in that power range - kylealers@gmail.com 08:53:25 08/11/15 (20)

Sure... - FenderLover 09:44:08 08/11/15 (19)

RE: Sure... - kylealers@gmail.com 09:52:22 08/11/15 (17)

None at all - FenderLover 13:57:31 08/11/15 (16)

RE: None at all - kylealers@gmail.com 12:17:55 08/12/15 (14)

Yes, only if you are going to use the tap in AC form - FenderLover 22:30:34 08/12/15 (13)

RE: Yes, only if you are going to use the tap in AC form - kylealers@gmail.com 22:39:15 08/12/15 (12)

100-ohm or 220-ohm will be fine. - FenderLover 00:20:44 08/13/15 (11)

RE: 100-ohm or 220-ohm will be fine. - kylealers@gmail.com 02:31:50 08/13/15 (9)

Cool! - FenderLover 07:13:20 08/13/15 (8)

RE: Cool! - kylealers@gmail.com 03:35:28 08/14/15 (7)

center tap - FenderLover 07:15:02 08/14/15 (6)

RE: center tap - kylealers@gmail.com 01:44:30 08/15/15 (5)

How did you want to "better" your PSU? - FenderLover 07:36:24 08/15/15 (4)

RE: How did you want to "better" your PSU? - kylealers@gmail.com 08:08:55 08/15/15 (3)

RE: How did you want to "better" your PSU? - FenderLover 08:38:36 08/15/15 (2)

RE: How did you want to "better" your PSU? - kylealers@gmail.com 02:33:38 08/16/15 (1)

RE: How did you want to "better" your PSU? - FenderLover 03:54:12 08/16/15 (0)

BTW... - FenderLover 00:21:58 08/13/15 (0)

You need to know... - FenderLover 06:35:22 08/12/15 (0)

Layout link - FenderLover 09:46:09 08/11/15 (0)

DS schematic - FenderLover 07:41:26 08/11/15 (0)

Portaflex B15N - FenderLover 23:18:35 08/10/15 (0)

Post a Message!