|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: JAN GE 5670 black burn marks on getter flashing posted by Chip647 on July 10, 2015 at 04:30:15:
Thank you so much for the advice. I would've been lost without this my heater circuit is running of a old 12v power supply for a internet modem would it ba safe to earth this with all the other earth's? or should I keep the circuit isolated because I'm having a bit of earth noise . One more question when I flick my standby on or off ,it clips and spikes heavily I was told to put a series resistor behind the switch but wouldn't that lower the voltage? And if I use the resistor what size should it be? And should it be on the negative or positive side? Sorry for all the questions in one post
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: JAN GE 5670 black burn marks on getter flashing - kylealers@gmail.com 04:51:14 07/10/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
