|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Lower filament voltage question.... posted by Aldovan on May 27, 2015 at 16:54:08:
"Is possible run the 6A3 with 5V on heaters without damage the tube ?"
I would say no but Steve Bench has done some work with starved filaments showing greatly reduced harmonic distortion.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Lower filament voltage question.... - Tre' 21:19:39 05/27/15 (4)
- RE: Lower filament voltage question.... - FenderLover 07:25:40 05/28/15 (3)
- Less actually - twystd 13:16:26 05/28/15 (2)
- No, I believe it's the heat in watts that is important. - FenderLover 14:47:31 05/28/15 (1)
- RE: No, I believe it's the heat in watts that is important. - twystd 15:38:37 05/28/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
