Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Aluminum finishing posted by sanman on April 13, 2015 at 18:05:34:
I've been using Deft Clear Wood Finish in Gloss. The photo above is an example of a recent project. Bear in mind this panel was textured with a random orbital sander first, so it doesn't show dust specs and other minor blemishes. This one stays on my workbench in the house, but another panel I sprayed about three years ago has been living in my non-climate-controlled garage with no apparent ill effects.Like I said before, the lacquer isn't very hard (compared to other commercial finishes), but it does prevent the aluminum from oxidizing. If you spray this over a mirror finish, you're breaking new ground. I've never used it that way, so there could be issues with cloudiness, adhesion etc. that I'm not aware of.
Edits: 04/13/15 04/13/15
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Aluminum finishing - Triode_Kingdom 18:23:17 04/13/15 (0)