|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Ask your "someone" if they thought of this. posted by finewatchrepair on January 25, 2015 at 18:22:20:
Not saying you should run 11.5 watts as that is close to the max dissipation. You would use the pot to fine tune the current draw so that the voltage on pin 3 is the same between tubes. 8 to 10 watts, just consistent. This has nothing to do with AC signal balance.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Ask your "someone" if they thought of this. - Chip647 05:04:58 01/26/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]