Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: HELP adjusting my EL84 modified cathode amp posted by finewatchrepair on January 24, 2015 at 16:39:15:
Usually on a fixed bias amp you measure across a 10 ohm resistor from cathode to ground. On a cathode biased amp you can measure from Pin 3 if you know the specific resistance of the cathode resistor.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Ask your "someone" if they thought of this. - Chip647 07:59:16 01/25/15 (8)
- RE: Ask your "someone" if they thought of this. - finewatchrepair 11:25:17 01/25/15 (7)
- RE: Ask your "someone" if they thought of this. - Chip647 13:27:12 01/25/15 (6)
- RE: Ask your "someone" if they thought of this. - finewatchrepair 18:22:20 01/25/15 (4)
- RE: Ask your "someone" if they thought of this. - Jim McShane 06:04:52 01/26/15 (2)
- RE: Ask your "someone" if they thought of this. - finewatchrepair 06:58:52 01/26/15 (1)
- RE: Ask your "someone" if they thought of this. - Jim McShane 10:09:27 01/26/15 (0)
- RE: Ask your "someone" if they thought of this. - Chip647 05:04:58 01/26/15 (0)
- RE: Ask your "someone" if they thought of this. - finewatchrepair 16:43:26 01/25/15 (0)