Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: It's adjusting them that's the issue posted by andy evans on January 14, 2015 at 09:03:25:
Hi Andy Evans
If by adjust you mean to set the bias, it is awfully quick and easy.
On the left side of each VPA are 2 small holes with regular screws inside.
You set the amp on mute.The upper hole is to set the bias of the front tube.
The red needle on the meter must be on the very tiny area (a little rectangle) on the left of the meter. You turn the screw till it goes there.
To set the rear tube, you keep on pushing on the button which is at the bottom right of the meter during the operation.
Thats it.
Best,
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: It's adjusting them that's the issue - JLV 14:08:03 01/21/15 (0)