Not necessarily

Posted by Michael Samra (D) on January 16, 2015 at 07:44:23

In Reply to: RE: power light posted by NuWave on January 16, 2015 at 07:03:47:

The ARC products use sensing circuits to make sure everything is right before it turns the unit on.It is in shut down because its sensing a problem with that tube most likely.Try pulling that tube out and reinserting it or clean the socket with a little dexoit from Radio Shack.It may have a little oxidation from sitting but if not,the tube is bad..I wouldn't suspect a bad solder connection as ARC doesn't typically have those but it is most likely in that tube..You could also take one of the other 6922s out and reverse it with that one to see if it lights up.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - VT 60 hopefully ok after sitting - NuWave 19:55:18 01/15/15 (21)

RE: VT 60 hopefully ok after sitting - kentaja 04:55:44 01/22/15 (2)

RE: wow - NuWave 17:32:32 01/31/15 (1)

RE: wow - kentaja 06:29:29 02/01/15 (0)

Good news or the bad news......? - NuWave 18:50:51 01/16/15 (3)

RE: Good news or the bad news......? - Michael Samra 11:14:11 01/17/15 (2)

no luck - NuWave 16:43:31 01/18/15 (1)

RE: no luck - Jonesy 11:02:57 01/21/15 (0)

RE: VT 60 hopefully ok after sitting - Caucasian Blackplate 10:18:24 01/16/15 (1)

RE: can't figure it out - NuWave 07:02:03 01/20/15 (0)

Could be a socket issue - Alpha Al 06:46:22 01/16/15 (6)

RE: Could be a socket issue - Michael Samra 08:18:16 01/16/15 (5)

RE: i'll try the swap tonight - NuWave 10:01:49 01/16/15 (4)

RE: i'll try the swap tonight - Alpha Al 14:17:24 01/16/15 (1)

RE: i'll try the swap tonight - Michael Samra 14:37:35 01/16/15 (0)

RE: i'll try the swap tonight - Caucasian Blackplate 10:26:48 01/16/15 (1)

RE: i'll try the swap tonight - NuWave 12:02:57 01/16/15 (0)

RE: VT 60 hopefully ok after sitting - Michael Samra 20:58:38 01/15/15 (4)

RE: VT 60 hopefully ok after sitting - Frihed89 01:36:34 01/16/15 (3)

RE: power light - NuWave 07:03:47 01/16/15 (2)

RE: power light - Frihed89 00:53:24 01/17/15 (0)

Not necessarily - Michael Samra 07:44:23 01/16/15 (0)

Follow Ups

Not necessarily - Michael Samra 07:44:23 01/16/15 (0)

Not necessarily

Post a Message!