Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Yes,it is very easy to do. posted by setamp on September 28, 2014 at 12:47:06:
You will be fine..If you have a 25 to 40 watt iron,just leave it on the pin longer to heat up and reflow some solder..Like Pete said,try not to get too much of a blob because then you need to take some off.. A 100 watt works best like black plate said but if you don't have one,just use what you have.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Yes,it is very easy to do. - Michael Samra 19:46:50 09/28/14 (3)
- RE: Yes,it is very easy to do. - setamp 06:19:44 09/29/14 (2)
- RE: Yes,it is very easy to do. - Michael Samra 09:48:59 09/29/14 (1)
- RE: Yes,it is very easy to do. - setamp 13:28:41 10/06/14 (0)