Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Yes,it is very easy to do. posted by setamp on September 28, 2014 at 12:47:06:
You would have to put in enough heat to actually melt the metal of the pins, which is unlikely.
If these are ceramic-based tubes, you could do this with a small butane torch. Otherwise, look for a 100W iron to allow for sufficient heating.
-PB
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Yes,it is very easy to do. - Caucasian Blackplate 14:21:32 09/28/14 (0)