Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Hickock Plate Voltage Measures High posted by FlaCharlie on August 6, 2014 at 08:17:27:
Charlie
It depends where you are referencing the voltages from..In the case of the filament,you are going across the windings but make sure you have that right rectifier tube in measure the voltage pin 3 and 8 of the octal socket when set for a 6550..As long as it reads 150vdc between those pins with the test switches engaged,you are good to go.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Hickock Plate Voltage Measures High - Michael Samra 18:08:14 08/06/14 (0)