|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: How did you narrow the problem down to couling cap(s)? posted by FenderLover on July 8, 2014 at 19:05:41:
Good question, FenderLover. I am not sure it is the coupling caps at all. Bad answer, I know, yet I don't have the proper equipment to test, and this is just an educated guess.
Idle bias was at 230mA, although now reads 0mA no matter where the dial is adjusted. The bias output now also reads ~24mV and ~16 Ohms no matter where the adjustment dial is placed, whereas typically the mV can be adjusted.
Thanks much for any insights on how to troubleshoot!
Kind regards,
Michael
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How did you narrow the problem down to couling cap(s)? - Nietzsche 19:36:16 07/08/14 (2)
- RE: How did you narrow the problem down to couling cap(s)? - Tre' 12:05:49 07/10/14 (0)
- Sounds like you need a good amp tech - FenderLover 21:29:13 07/08/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
