|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Tube specification help posted by mnilan on May 26, 2014 at 08:51:28:
If your amp uses 4 6sn7s, one pair are probably input tubes and one pair are drivers for the 300bs. I would have the pairs matched but not necessarily all 4. You can use 4 of the same type, but I would suggest using different pairs of tubes for the driver and input sections. Gives you more room to "flavour" the amp to your liking.
Lots of info here on which 6sn7s people like for each job but until you try them in your amp and system you won't know what you like best.
Enjoy the roll!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Tube specification help - Mendel 06:37:34 05/29/14 (3)
- RE: Tube specification help - mnilan 09:15:55 05/29/14 (2)
- RE: Tube specification help - Mendel 09:38:29 05/29/14 (1)
- Thanks again! -nt - mnilan 17:03:30 05/29/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
