I don't doubt the quality one bit when I looked at the inside of one.

The boards are the same type as tubes4hifi use on a lot of their products and most of the parts are off the shelf components of excellent quality.My only concern is if the owner retires or passes away as did one person already that makes these higher priced testers,will we be able to get service literature or the software to burn a new chip that may fail down the road? I would be happy with a basic schematic and alignment instructions should an issue an arise in later years when you are likely to have problems.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - I may pull the trigger on an Amplitrex that is three years old. - Michael Samra 18:14:54 05/20/14 (14)

RE: I may pull the trigger on an Amplitrex that is three years old. - MP53 14:39:54 05/23/14 (0)

RE: I may pull the trigger on an Amplitrex that is three years old. - bcguitar 08:19:30 05/21/14 (0)

Tell us how you like this tester - FenderLover 07:11:45 05/21/14 (6)

RE: Tell us how you like this tester - Jim McShane 09:27:30 05/21/14 (5)

To Jim and others. - Michael Samra 12:50:08 05/21/14 (4)

RE: To Jim and others. - Jim McShane 15:54:30 05/21/14 (1)

RE: To Jim and others. - FenderLover 11:19:44 05/22/14 (0)

RE: To Jim and others. - Byrd69 14:58:46 05/21/14 (1)

It happens..I also most pulled the trigger on this tester but it was only - Michael Samra 16:42:00 05/21/14 (0)

RE: I may pull the trigger on an Amplitrex that is three years old. - Barry 20:33:15 05/20/14 (0)

RE: I may pull the trigger on an Amplitrex that is three years old. - Jim McShane 20:01:27 05/20/14 (2)

I don't doubt the quality one bit when I looked at the inside of one. - Michael Samra 03:51:26 05/21/14 (1)

RE: I don't doubt the quality one bit when I looked at the inside of one. - glenz10183@aol.com 06:39:14 05/21/14 (0)

That is my main reason for holding back - Byrd69 19:13:37 05/20/14 (0)

Follow Ups

I don't doubt the quality one bit when I looked at the inside of one. - Michael Samra 03:51:26 05/21/14 (1)

RE: I don't doubt the quality one bit when I looked at the inside of one. - glenz10183@aol.com 06:39:14 05/21/14 (0)

I don't doubt the quality one bit when I looked at the inside of one.

Post a Message!