Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Take several measurements at different times of the day posted by FenderLover on May 14, 2014 at 19:41:28:
Somethings been nagging at me. When I used to check my output bias and DC balance every 6 months or so, I thought I always had to change from DC mA to DC volt settings along with switching one of the test leads. But at some point I recall getting zero reading set at DC mA for output so thought I was mistaken and both tests were to be done on the same DC volt setting, because only then would I get any readings.
But reading through past posts I think it should be DC mA for output and DC volt for balance. I know not to touch A.C. balance as I need a scope.
Either I've gone crazy or my DVM has. Hopefully the latter.
Jonesy
"I know just enough to get into trouble. But not enough to get out of it."
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I'm going to try a different DVM also... - Jonesy 21:50:19 05/14/14 (2)
- RE: I'm going to try a different DVM also... - FenderLover 01:01:00 05/15/14 (1)
- Ok. I'm good then... - Jonesy 20:51:51 05/15/14 (0)