Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Yeah, check the plate voltages when the bias reads differently posted by Jonesy on May 14, 2014 at 10:56:23:
`Check the plate voltage at pin number 3 of each of the 6550 tubes.Also check the negative voltage at pin 5 and see if it changes.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Yeah, check the plate voltages when the bias reads differently - Michael Samra 15:17:07 05/14/14 (5)
- RE: Yeah, check the plate voltages when the bias reads differently - Jonesy 15:53:34 05/14/14 (4)
- Take several measurements at different times of the day - FenderLover 19:41:28 05/14/14 (3)
- I'm going to try a different DVM also... - Jonesy 21:50:19 05/14/14 (2)
- RE: I'm going to try a different DVM also... - FenderLover 01:01:00 05/15/14 (1)
- Ok. I'm good then... - Jonesy 20:51:51 05/15/14 (0)