Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Dead Silence posted by Jonesy on April 9, 2014 at 17:57:21:
I want you to desolder the 1uf coupling caps C9 and C10 on the side that goes to the output tubes control grid and the 1k resistor..There are four of these caps and I only see C9 and C10 in the schematic as they are showing one channel..Anyway,the side that you lift up on each,plug the amp back in and measure the DC voltage on the desoldered side of each cap to ground..If it reads more than a half volt,change the cap as its leaky.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Ok then here is the schematic - Michael Samra 04:41:39 04/10/14 (7)
- 1K Resistor Location? - Jonesy 14:55:19 04/10/14 (3)
- Can't find any 1K resistors - Jonesy 17:59:44 04/10/14 (2)
- RE: Can't find any 1K resistors - Michael Samra 09:25:02 04/11/14 (1)
- RE: Can't find any 1K resistors - Jonesy 09:50:20 04/11/14 (0)
- Ah man. I want to stay home from work... - Jonesy 06:03:19 04/10/14 (2)
- RE: Ah man. I want to stay home from work... - Michael Samra 13:01:03 04/10/14 (1)
- Was a time... - Jonesy 13:30:41 04/10/14 (0)