Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Me Again (Ping Mike... Anyone?) posted by Jonesy on April 8, 2014 at 19:13:11:
Jonesy
I think you are worried too much about this..Bias is always set under DC static conditions.If the bias varies a tiny bit with the signal tubes installed,that is not a big deal.Short the inputs as Steve suggested and then set the bias.If it varies a lot,you could be picking up noise or a oscillation somewhere but let us know how much it changes when you put the signal tubes in.
A coupling cap can cause that issue as well..Did you change your output couplers?
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Edits: 04/08/14 04/09/14
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Me Again (Ping Mike... Anyone?) - Michael Samra 20:28:16 04/08/14 (19)
- Does this drifting occur with only the phase inverter and output tubes? - FenderLover 00:38:09 04/09/14 (18)
- RE: Does this drifting occur with only the phase inverter and output tubes? - Jonesy 11:37:40 05/12/14 (0)
- Mike, Steve, Fender Lover - Jonesy 09:04:34 04/09/14 (16)
- RE: Mike, Steve, Fender Lover - Michael Samra 11:26:09 04/09/14 (15)
- RE: Mike, Steve, Fender Lover - Jonesy 12:25:05 04/09/14 (14)
- RE: Mike, Steve, Fender Lover - Michael Samra 13:30:02 04/09/14 (13)
- Shorting plugs in... - Jonesy 16:38:49 04/09/14 (12)
- That's unfortunate... - Steve O 18:32:10 04/09/14 (1)
- RE: That's unfortunate... - Jonesy 19:00:41 04/09/14 (0)
- Answer me this - Michael Samra 17:24:11 04/09/14 (9)
- Dead Silence - Jonesy 17:57:21 04/09/14 (8)
- Ok then here is the schematic - Michael Samra 04:41:39 04/10/14 (7)
- 1K Resistor Location? - Jonesy 14:55:19 04/10/14 (3)
- Can't find any 1K resistors - Jonesy 17:59:44 04/10/14 (2)
- RE: Can't find any 1K resistors - Michael Samra 09:25:02 04/11/14 (1)
- RE: Can't find any 1K resistors - Jonesy 09:50:20 04/11/14 (0)
- Ah man. I want to stay home from work... - Jonesy 06:03:19 04/10/14 (2)
- RE: Ah man. I want to stay home from work... - Michael Samra 13:01:03 04/10/14 (1)
- Was a time... - Jonesy 13:30:41 04/10/14 (0)