Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Me Again (Ping Mike... Anyone?) posted by Jonesy on April 8, 2014 at 17:40:50:
At the risk of stating the obvious....there should be no input signal while setting bias. Have you tried shorting the inputs?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Me Again (Ping Mike... Anyone?) - Steve O 19:02:57 04/08/14 (22)
- RE: Me Again (Ping Mike... Anyone?) - Jonesy 19:13:11 04/08/14 (21)
- RE: Me Again (Ping Mike... Anyone?) - Steve O 20:49:21 04/08/14 (0)
- RE: Me Again (Ping Mike... Anyone?) - Michael Samra 20:28:16 04/08/14 (19)
- Does this drifting occur with only the phase inverter and output tubes? - FenderLover 00:38:09 04/09/14 (18)
- RE: Does this drifting occur with only the phase inverter and output tubes? - Jonesy 11:37:40 05/12/14 (0)
- Mike, Steve, Fender Lover - Jonesy 09:04:34 04/09/14 (16)
- RE: Mike, Steve, Fender Lover - Michael Samra 11:26:09 04/09/14 (15)
- RE: Mike, Steve, Fender Lover - Jonesy 12:25:05 04/09/14 (14)
- RE: Mike, Steve, Fender Lover - Michael Samra 13:30:02 04/09/14 (13)
- Shorting plugs in... - Jonesy 16:38:49 04/09/14 (12)
- That's unfortunate... - Steve O 18:32:10 04/09/14 (1)
- RE: That's unfortunate... - Jonesy 19:00:41 04/09/14 (0)
- Answer me this - Michael Samra 17:24:11 04/09/14 (9)
- Dead Silence - Jonesy 17:57:21 04/09/14 (8)
- Ok then here is the schematic - Michael Samra 04:41:39 04/10/14 (7)
- 1K Resistor Location? - Jonesy 14:55:19 04/10/14 (3)
- Can't find any 1K resistors - Jonesy 17:59:44 04/10/14 (2)
- RE: Can't find any 1K resistors - Michael Samra 09:25:02 04/11/14 (1)
- RE: Can't find any 1K resistors - Jonesy 09:50:20 04/11/14 (0)
- Ah man. I want to stay home from work... - Jonesy 06:03:19 04/10/14 (2)
- RE: Ah man. I want to stay home from work... - Michael Samra 13:01:03 04/10/14 (1)
- Was a time... - Jonesy 13:30:41 04/10/14 (0)