Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: D70 Output Tubes Drifting WHILE Biasing posted by Michael Samra on March 24, 2014 at 13:09:04:
Hi Mike,
I would like to remove some tubes as you suggested.
So I would leave in the output tubes, the power tube, and the 12ax7 that is part of the power supply.
Take out 2 driver and 1 signal tube per channel.
Take out the phase splitter tube, which I believe is part of driver and signal tube circuit.
Then I would turn the unit on, and check the bias on the output tubes.
Sound right?
Jonesy
"I know just enough to get into trouble. But not enough to get out of it."
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: D70 Output Tubes Drifting WHILE Biasing - Jonesy 08:47:15 03/28/14 (0)