Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: D70 Output Tubes Drifting WHILE Biasing posted by Michael Samra on March 24, 2014 at 13:09:04:
I swapped out all the driver and phase splitter tubes, rather than leaving them empty. 1 trim pot appears to have tightened up but no change to the other 3. Baffling. I guess I should just take them out altogether. All the rolling and letting the amp warm up each time takes awhile. Going to watch some hockey and back at her tomorrow.
Thanks again.
Jonesy
"I know just enough to get into trouble. But not enough to get out of it."
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: D70 Output Tubes Drifting WHILE Biasing - Jonesy 18:15:35 03/24/14 (2)
- RE: D70 Output Tubes Drifting WHILE Biasing - Lee of Omaha 09:31:25 03/25/14 (1)
- RE: D70 Output Tubes Drifting WHILE Biasing - Jonesy 10:23:26 03/25/14 (0)