Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Output Impedance Question??? posted by ecline6 on February 27, 2014 at 19:13:21:
...until the amp is driven at a high-enough level so that the amp runs out of power. There's no harm in using either output tap with either speaker load. I'd say your preferred tap is the 4-Ohm one. FWIW, the amp has twice the damping factor from 4- rather than from 8-Ohms.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- The 8-Ohm tap produces higher Voltage which translates into higher speaker level... - jeffreybehr 21:47:41 02/27/14 (0)