Home Tubes Asylum

Questions about tubes and gear that glows. FAQ

may have found the problem...

I started doing resistance checks again and notices that the area where the that 200k resistor (the one that was mearsuring 210k)and 100 ohm resistor attached to the Source lead of the Mosfet in the bad left channel was measuring 2.1 meg to ground. The good channel was measuring around 200k to ground. snipped the Source lead of the Mosfet in the bad channel and measurement immediately went to 200k, did the other mosfet too which was measuring close to 200k and now has the same measurement of 200k. I must have damaged the Mosfet in the left channel when I was either changing it or was damaged due to the original 200k resistor being out of tolerance. Hopefully this will be the cause of that hum.

I will post back the results in a few days.


This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Follow Ups Full Thread
Follow Ups
  • may have found the problem... - Cougar 13:56:55 04/14/13 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.