Tubes Asylum

Clarification Needed

65.205.15.220

In Reply to: RE: It is more of the tube than just the amp. . . posted by John PA on May 12, 2008 at 13:50:46

The original poster claims that the bias is stated in volts, not milliamperes, though the .34v does not make sense. If his bias setting is in volts, he needs a higher voltage to reduce the current flowing in the tube, if the reading is in milliamps, then a lower figure is what is needed to run the tubes more conservatively.

Follow Ups:

RE: Clarification Needed - Chris O 15:27:38 05/12/08 (10)
- RE: Clarification Needed - REL54 16:13:08 05/12/08 (9)
  - RE: Clarification Needed - rr1405 10:27:45 05/13/08 (6)
    - I use the DC mA setting on my Multimeter, not the DCV..... - Chuck Y 11:46:42 05/13/08 (5)
      - RE: I use the DC mA setting on my Multimeter, not the DCV..... - rr1405 12:01:06 05/13/08 (4)
        
        If you mean you just checked using the dc ma setting...... - Chuck Y 13:00:46 05/13/08 (3)
        
        RE: If you mean you just checked using the dc ma setting...... - rr1405 16:37:09 05/14/08 (2)
        
        RE: If you mean you just checked using the dc ma setting...... - Chuck Y 18:26:57 05/14/08 (1)
        
        RE: If you mean you just checked using the dc ma setting...... - rr1405 08:28:02 05/16/08 (0)
  - check the solder joints on all sockets too... - Jonesy 16:49:03 05/12/08 (1)
    - Yes, my first thought would always be Chinese quality control! - Frihed89 06:13:08 05/13/08 (0)

Post a Followup:

FAQ

Post a Message!

Forgot Password?

Moniker (Username):
Password (Optional):
	Remember my Moniker & Password (What's this?) Eat Me
E-Mail (Optional):
Subject:

Message:	(Posts are subject to Content Rules)

Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:	Automagically notify you when someone responds.

To view your new posting or follow-up, click on the RELOAD or REFRESH button on your browser.