|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: 211 bias settings posted by Sturmey on October 7, 2004 at 09:23:43:
HI Jeff,
When replacing the EL34's, I have found that the bias should at least be checked as they can vary as a driver tube causing fluctuations in the bias.
Here is another thing to try. Swap the 211 with another one in one of the amps to see if it will bias in a different location. It could justbe a bad power tube. If you getthe same result for this tube in another socket, replace that tube. Also check to see if the tube you installed in this socket you took the tube from will bias.
Process of elimination.
Let me know your findings. You can also email me and I can give you my number if you would like to discuss this in person over the phone rather than on the board.
Happy Listening,
Response34
Build your system for yourself, not the critics!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: 211 bias settings - Response34 10:18:23 10/07/04 (1)
- Re: 211 bias settings - Sturmey 12:27:20 10/07/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
