vibrato channel dead in '74 fender twin

Tubes Asylum

Questions about tubes and gear that glows. FAQ

hi folks
i switched twin on today and no signal in vibrato channel although normal channel worked fine. I tried swapping pre amp valves around to no avail and solder points all seem ok. Earlier this week i had changed a couple of caps [ .002uf 1KV on reverb output and .003uf 1Kv on circuit board ] and it had still worked when i did this but I put the original caps back in to see if it would help but this did not cure it. The reverb send valve is extremely hot [ i would say even hotter than usual ]. Any clues or suggestions would be much appreciated
thanks - rob

This post is made possible by the generous support of people like you and our sponsors:

Signature Sound

[ Signature Sound Lounge ]

Topic - vibrato channel dead in '74 fender twin - rej5963@hotmail.com 14:44:23 10/04/04 (1)

Re: vibrato channel dead in '74 fender twin - zarniwoop 14:24:22 10/05/04 (0)

You can not post to an archived thread.