Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Disagree posted by Russ57 on September 17, 2004 at 10:05:21:
But I am going to measure voltages just in case. It should read 22 volts at the output of the silicon bridge.You say that higher voltages are preferrable. If so, isn't tube life compromised? It's a well known fact that filaments/heaters that run below rated voltages will last longer.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Yes, indeed. They are series connected.. - crooner 11:16:27 09/17/04 (3)
- Actually... - Russ57 12:03:26 09/17/04 (2)
- I am going to follow your suggestion... - crooner 18:43:40 09/17/04 (1)
- About lasting as long - Russ57 07:36:50 09/18/04 (0)