|
Speaker Asylum General speaker questions for audio and home theater. |
|
|
|
Speaker Asylum General speaker questions for audio and home theater. |
|
In Reply to: Re: measurements posted by Jeff Joseph on September 25, 2001 at 10:41:07:
JA uses 2.83V at 1 meter for sensitivity measurements with B weighting, so this is not a true 1 watt @ 1 meter senstivity measurement. It would be if the speakers impedance over the weighting range was 8 ohms (1 watt = 2.83 Vrms into a 8 ohm load), but the average impedance looks higher than that to me (except for that short dip to 6 ohms at 500 to 500 Hz) which would mean that the 1 watt at 1 meter sensitivity for the speakers could well be a couple dB higher than the 80dB and account for another part of the difference between Jeff's specs and JA's measured number.
Rich Brkich
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: measurements - Rich Brkich 12:31:26 09/25/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
