|
Speaker Asylum General speaker questions for audio and home theater. |
|
|
|
Speaker Asylum General speaker questions for audio and home theater. |
|
In Reply to: How to remove casters from B&W Matrix 801 Series II posted by George S. Roland on November 8, 2016 at 10:56:36:
In case this is of interest to anyone in the future, I spoke with the folks at Sound Anchors and found out that there were two kinds of casters used on these speakers. Some were bolted on and have an obvious nut that can be unscrewed. The others, like mine, are pull-off. They were incredibly stuck on, so I tried gentle tugging with a claw hammer. Two came out easily, two pulled out the inserts with the casters. In subsequent conversation with North Creek and Sound Anchors, it turns out I can actually leave the casters in after the crossover mods and the installation of the stands, so I plan on just putting them all back in place when the job's done.
Thanks to responders!
George
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How to remove casters from B&W Matrix 801 Series II - George S. Roland 18:10:02 11/09/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
