In Reply to: Active bi-amping on three way speakers posted by KanedaK on August 12, 2016 at 01:54:37:
It has been my experience that individual speakers are all connected in parallel to the crossover system. Therefore, you should not need to install a resistor in place of any speaker. You should be able to simply disconnect the woofer and associated crossover components and drive the midrange and tweeter normally from the speaker binding posts using a full range amplifier. Then you can connect the woofer directly to another amplifier with an active low-pass crossover ahead of the amplifier.
Good luck,
John Elison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Active bi-amping on three way speakers - John Elison 08:53:23 08/12/16 (0)