|
Speaker Asylum General speaker questions for audio and home theater. |
|
|
|
Speaker Asylum General speaker questions for audio and home theater. |
|
In Reply to: RE: Dunlavy SC-V questions and opinions wanted posted by David Yost on May 12, 2016 at 10:53:16:
Apply some painter's tape along the side where the back and sides meet. Use yellow carpenter's glue and work it under the veneer with a thin blade screw driver. Use a piece of 3/4" plywood as long as necessary to cover the length of the repair and about 6 or 8" wide as a caul. Let it overhang the edge a half inch or so. You can either clamp along the edge or if you have heavy weights, place on top of the plywood caul and allow to dry for a couple of hours. Wipe any squeeze out of glue with a damp rag.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Dunlavy SC-V questions and opinions wanted - Mr. Dick Hertz 11:29:01 05/12/16 (2)
- RE: Dunlavy SC-V questions and opinions wanted - David Yost 13:05:43 05/12/16 (1)
- RE: Dunlavy SC-V questions and opinions wanted - Mr. Dick Hertz 13:36:51 05/12/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
