Home Speaker Asylum

General speaker questions for audio and home theater.

RE: High and low frequencies getting confused.

I mean to A/B my Paradigms again to reconfirm that I noticed an improvement, and at the time it seemed fairly pronounced. I will say I tried the same on some Epos that I had around and they did not seem to make a difference. Also need to mess around with some different jumpers.

It may be somewhat speaker dependent - or in my case the Paradigms are version 2 so probably about 15 years old at this point - I bought them used - so in terms of the electronics the age could be some sort of factor. I just picture that the previous owner single wired them all these years and I was the first to connect a bi-wire

Also noticed it is possible to wire them with jumpers in place - one wire polarity to the bottom set and the other to the top set which would be a bit different current path then using one set of posts, but I don't know what that would mean exactly
JaroTheWise


This post is made possible by the generous support of people like you and our sponsors:
  Herbie's Audio Lab  


Follow Ups Full Thread
Follow Ups
  • RE: High and low frequencies getting confused. - JaroTheWise 14:46:23 07/22/15 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.