Home Speaker Asylum

General speaker questions for audio and home theater.

RE: Without knowledge it won't make sense

Both cables in a passive bi-wire setup have the same electrical POTENTIAL.

IT's true, "the high pass low pass causes the CURRENT (not content) measured in milliamperes, of the wires to be different".

What exists in the wire untill the circuit is closed is an electrical potential, that can be measured with a VOLT METER or a FREQUENCY METER but not an AMMETER because without electrical continuity (a circuit) to a LOAD there is NO CURRENT or milliamperes.

If you were to separate the two wires on your toaster and place a clamp-on ammeter on one of the wires, you would not see any amperage (current) untill depressing the lever to make toast.

Your statement "and once it is closed with a filter in place then only the unfiltered content (current) will be running in it" is correct.

Regards, Craig




This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.