Attached is the schematic for a set of crossovers I will be rebuilding. There is one difference between mine and the schematic. R2 is not used. I'm curious what effect, if any, there would be with the resistor included vs excluded. I have two pair of these crossovers and neither has the resistor. There is a place on the boards that had never been used. I don't know if a change was made before or after mine were manufactured.
I can measure the inductors, but don't know how to convert uH to the given spec so will assume no change had been made there.
Thanks for any help.
sf
Edits: 12/13/14
This post is made possible by the generous support of people like you and our sponsors:
Topic - Schematic help please - Steve Franklin 13:49:45 12/13/14 (7)
- RE: Schematic help please - Steve Franklin 07:05:49 12/16/14 (0)
- Note Resistors are 4 watt ... - Rick58 04:39:43 12/16/14 (1)
- RE: Note Resistors are 4 watt ... - Lou S 18:11:42 12/27/14 (0)
- RE: Schematic help please - Frihed89 01:19:45 12/14/14 (0)
- RE: Schematic help please - Presto 16:09:29 12/13/14 (1)
- RE: Schematic help please - Steve Franklin 00:10:05 12/14/14 (0)
- RE: Schematic help please - airtime 14:59:46 12/13/14 (0)