In Reply to: RE: Tweeter with built in x-over? posted by DavidLD on September 5, 2014 at 05:14:41:
Here is how an LPad gets wired into an ordinary DIY speaker
Terminal 1 is the ground connected to the - side of the . Terminal 3 goes thropugh whatever caps or other crossover parts there are in the circuit. Termiinal 2 is just a wire direct to the + side of the tweeter.
Figuring out which wire on the tweeter is the ground should be easy. Chances are the crossover on the tweeter is just a cap. In bypassing the LPAD that is no longer there you would pass the plus side of the speaker circuit to the wire with the cap in series and probably just leave the third wire disconnected.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Tweeter with built in x-over? - DavidLD 05:27:43 09/05/14 (1)
- RE: Tweeter with built in x-over? - Hodgie 05:44:50 09/06/14 (0)