98.223.11.100
'); } else { document.writeln(''); } } else { document.writeln(''); } } else { document.writeln(''); } } // End --> |
This Post Has Been Edited by the Author
In Reply to: RE: Blown resistor posted by sgdouglas@dccnet.com on March 06, 2012 at 16:58:46
If the resistors are "a driver protection Mechanism" in addition to ohm rating you should give serious attention to the wattage rating of your replacement resistors.
So not only do you need to match the ohm rating of your original resistors but also the wattage rating.
Follow Ups: