68.103.13.92
'); } else { document.writeln(''); } } else { document.writeln(''); } } else { document.writeln(''); } } // End --> |
This Post Has Been Edited by the Author
In Reply to: RE: Blown resistor posted by sgdouglas@dccnet.com on March 04, 2012 at 20:52:30
47 is 3 less than 50 & 56 is 6 more than 50. 3/50=0.06 or 3 is 6% of 50. Typically such crossover parts themselves have +,-10% deviation per value-as-marked tolerances, so replacing a 50-ohm part with a 47-ohm part is not only OK, but within part specification. If only a 56-ohm part is available (or readily so), even that will be fine but 47 is the better choice of those two.
Edits: 03/05/12Follow Ups: