Home Speaker Asylum

General speaker questions for audio and home theater.

RE: 4 ohms vs. 8 ohms

Looking at the Stereophile review these speakers dip to 4 ohms in a couple of spots despite their 6 ohm rating. This can be expected in some cases with "nominal" loads. Impedance is not a "number" - it's a frequency dependent phenomenon, aka a graph.

Your speakers are 6ohm so according to the manual you can set the switch to the "HIGH" impedance position.

If you get amp overheating or distortion, you should try the "LOW" setting.

This amp is rated down to TWO OHMS which is amazing for an amp in this price range. Due to it being only a 2 channel amp (weighing in at 26 pounds) they had room for wonderfully large heatsinks in there.

Survey Says: Set it to HIGH and give her a go! Risk to the amp is almost non-existant.

Cheers,
Presto


This post is made possible by the generous support of people like you and our sponsors:
  Upscale Audio  


Follow Ups Full Thread
Follow Ups
  • RE: 4 ohms vs. 8 ohms - Presto 10:36:34 03/15/12 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.