In Reply to: Sensitivity posted by fred g on October 23, 2010 at 12:56:28:
>When a crossover is added to the equation does it change the sensitivity?
>More, less or about the same?
Less or the same with only one driver in each pass band.
Speakers built for use away from walls are usually padded down 3-5dB at high frequencies to match their low frequency SPL below the baffle step where they've gone from half space to full-space radiation.
Where the woofer is being used above a few hundred hertz (where baffle step would be) and above floor level that's probably your situation.
OTOH, a floor mounted woofer is picking up 5-6dB since it starts off operating into quarter space and transitions to half space. System sensitivity would be that of the higher frequency drivers.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Sensitivity - Drew Eckhardt 19:08:53 10/23/10 (1)
- Best answer right here... - BigguyinATL 11:54:17 10/26/10 (0)