In Reply to: Alternative to jumpers when single-wiring posted by BRab on March 31, 2007 at 15:38:44:
Neither of you below have understood what he's done but I'll put that down to my inadequate description. Because the wires from the high and low pass sections of the crossover are now connected to the same internal part of one binding post he has in fact eliminated per speaker, two jumpers (one hot and one ground)and bypassed two (one hot and one ground)of the four binding posts entirely, i.e. inside and out. If this doesn't matter than neither would cobbling together an eight foot run of speaker wire by combining two four foot sections with a binding post between them.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Alternative to jumpers when single-wiring - BRab 09:41:12 04/01/07 (1)
- Well, if you want to believe it then go for it. - Markw* 15:08:19 04/01/07 (0)