In Reply to: MGIIIa tweeter help posted by Bullet on March 24, 2007 at 06:20:50:
The best way to check maggie tweeters is to fully disconnect them from the XO circuit (i.e. un-do the spade-type connectors from each end). You do not need to physically remove them off the MDF panel nor should you need to remove the covers.You take your resistance readings by placing the meter leads at each contact end-tab of the tweeter. You should get a reading in the 3.xx ohm range. If you observe a null reading, then the tweeter is dead.
Good luck ...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: MGIIIa tweeter help - Brian_T 04:00:48 03/26/07 (0)