RE: Thanks, Todd ...

General Asylum

General audio topics that don't fit into specific categories.

Follow Ups Full Thread

Topic - Does the followin compoent have to be switched on, for signal to flow through the PREceeding component? - andyr 13:06:33 08/16/15 (22)

RE: Does the followin compoent have to be switched on, for signal to flow through the PREceeding component? - Caucasian Blackplate 10:18:36 08/17/15 (1)

RE: Yes, it does ... - andyr 13:46:27 08/17/15 (0)

RE: Does the followin compoent have to be switched on, for signal to flow through the PREceeding component? - Todd Krieger 19:19:11 08/16/15 (2)

RE: Does the followin compoent have to be switched on, for signal to flow through the PREceeding component? - JKT 21:22:44 08/16/15 (0)

RE: Thanks, Todd ... - andyr 19:55:44 08/16/15 (0)

The load the phono stage will see, almost certainly a resistor and likely a cap - bjh 15:21:19 08/16/15 (4)

RE: "vol. control of pre has nothing to do with it" - 1973shovel 02:19:57 08/17/15 (0)

RE: The load the phono stage will see, almost certainly a resistor and likely a cap - JKT 16:34:03 08/16/15 (2)

RE: The load the phono stage will see, almost certainly a resistor and likely a cap - bjh 17:28:04 08/17/15 (0)

RE: The load the phono stage will see, almost certainly a resistor and likely a cap - andyr 18:22:16 08/16/15 (0)

Turn the volume control of your preamp up full - 1973shovel 13:49:58 08/16/15 (2)

RE: Thanks - good point. nt - andyr 14:54:10 08/16/15 (1)

And back down again afterwards (nt - genungo 17:29:43 08/16/15 (0)

RE: Does the followin compoent have to be switched on, for signal to flow through the PREceeding component? - Inmate51 13:45:42 08/16/15 (6)

You Cannot Turn a Speaker Off........ - Todd Krieger 19:01:08 08/16/15 (0)

RE: Does the followin compoent have to be switched on, for signal to flow through the PREceeding component? - marc g. 14:09:25 08/16/15 (0)

RE: "if you tell me what the 'pertinent measurements' are ... I'll make them. ;-)) nt - andyr 13:49:37 08/16/15 (3)

RE: "if you tell me what the 'pertinent measurements' are ... I'll make them. ;-)) nt - Inmate51 17:22:54 08/16/15 (2)

RE: "if you tell me what the 'pertinent measurements' are ... I'll make them. ;-)) nt - PAR 01:35:59 08/17/15 (0)

RE: When are you going to deliver all that test equipment to me? ... - andyr 18:20:05 08/16/15 (0)

RE: Does the followin compoent have to be switched on, for signal to flow through the PREceeding component? - neolith 13:30:05 08/16/15 (1)

RE: Thanks, neo ... - andyr 13:51:13 08/16/15 (0)

Follow Ups

RE: Thanks, Todd ... - andyr 19:55:44 08/16/15 (0)

Post a Message!