|
General Asylum General audio topics that don't fit into specific categories. |
|
|
|
General Asylum General audio topics that don't fit into specific categories. |
|
In Reply to: RE: Warranty? posted by RGA on November 29, 2014 at 20:14:18:
What about 'worst case scenario' of 2 amps using the SAME schematic for build. The first amp uses high MTBF semiconductors, ample heat sinking and does a 100 hour factory burn-in at from 20% to 80% power THAN readjusts bias and PS offset. They also use REAL glass Expoxy boards, all 1% or better film resistors and 5% caps, where available.
AMP #2 just buys 'whatever', uses pressed cardboard circuit boards and has a 15% in-line rejection rate on finished goods.
Who are you going to buy? If I like the amp, I'll spend whatever it takes to GET it and skip the stuff which may SOUND alike, but for how long?
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Warranty? - pictureguy 20:36:45 11/29/14 (1)
- RE: Warranty? - RGA 00:06:47 11/30/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
