In Reply to: RE: Really Victor? I didn't know that.. posted by jea48 on August 19, 2014 at 22:15:49:
Simply disconnect the equipment from each other and then measure the AC voltages between their chassis and between their signal grounds, in many cases you will see significant voltages present. Sometimes because the signal ground is, in some way, connected to the safety ground, sometimes due to induced potential, but it is often there.
Putting in the sub-panel pretty much eliminates this.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Really Victor? I didn't know that.. - Victor Khomenko 05:40:47 08/20/14 (5)
- RE: Really Victor? I didn't know that.. - jea48 10:27:55 08/20/14 (4)
- RE: Really Victor? I didn't know that.. - BCR 18:22:00 08/25/14 (1)
- RE: Really Victor? I didn't know that.. - jea48 20:10:00 08/25/14 (0)
- RE: Really Victor? I didn't know that.. - MylesJ 11:18:51 08/25/14 (1)
- RE: Really Victor? I didn't know that.. - jea48 13:53:41 08/25/14 (0)