|
Digital Drive Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it. |
|
|
|
Digital Drive Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it. |
|
In Reply to: What's yer recipe for the roller blocks? posted by rhizomatic on May 20, 2003 at 10:41:15:
Hi,
Not much to them so I'll describe them from top to bottom. I made the top from a piece of 7075 T-6 aluminium with a hole bored thru the middle. In the hole I put a hardened steel liner (thinking it was 1/2" I.D.). The outside was an 1 1/4" and about 5/8th tall. The bottom half was similar, but larger in diameter at 1 3/4". These two blocks are seperated with a hardened ball bearing (3/4" if I remember correctly). I have not, but do plan on trying an o ring under the bottom puck. Have no idea if a larger ball, or smaller liner would have made a difference in the sound. All I know is that it threw it so far forward that we had to actually change our listening position.
glt
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: What's yer recipe for the roller blocks? - Gary 00:22:14 05/21/03 (1)
- Re: What's yer recipe for the roller blocks? - gary 10:50:23 05/24/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
