|
Digital Drive Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it. |
|
|
|
Digital Drive Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it. |
|
In Reply to: New T-Amp Connectivity Question? posted by Cable_Designer on August 2, 2014 at 08:49:52:
I am not sure what your question is???
Most T-Amps, including the one you asked about, have a volume control and the equivalent to a preamp built in. There is no need to run the outputs of the this T-Amp to anything but speakers. The amp outputs 100-watts at 6-ohms and 80-watts at 8-ohms. (see the specs in the link below).
However if you use the outputs of this T-Amp as input to a preamp - you stand a good chance of damaging the preamp. I hope this helps.
DaveT
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: New T-Amp Connectivity - DaveT 11:17:06 08/02/14 (1)
- RE: New T-Amp Connectivity - Cable_Designer 16:57:33 08/02/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]