Home Digital Drive

Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Digital Drive ]
[ Alert Moderator ]

Lynx and RME cards.

Christine:

Most lynx and RME cards can be slaved to an external clock source.

If you have a good DAC with a wordclock output, you can run in synchronous mode.

Honestly, I do not know why folks spend $1000 on a soundcard and then run clocked SPDIF to a $3000 DAC. It just does not make sense to me. Clocked consumer spdif with an ASRC's is only going to get one so far IMHO. Even when using the Lynx 2B for analog outputs, I think you can slave the card and use an external clock source. Few seem to bewail this setup. If it were me, and if I owned the Lynx, I would be DYING to try an external clock source that was battery powered instead of using a PC GENERATED clock. Yick! :^D

What are your thoughts on having a master clock in the DAC and slaving the transport / soundcard to it?

Cheers,
Presto

This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]